Emerson Rosemount Wireless WT210 Quick Start Manual page 10

Quick Start Guide
Note
Use of Universal Mount Holder and pre-cutting Strap to length
are recommended for 'hot pipe' installations in particular.
3.2 Surface preparation
On painted pipework, remove a singular patch of the coating about
1-in. (25 mm) diameter in the location you wish to monitor to allow
waveguides to contact pipe directly.
3.3 Strap mount installation
WARNING
Two people are required for this operation
Personal protective equipment (PPE) of gloves and safety glasses or
full-face visor are recommended.
Cut strap may have sharp edges.
DO NOT cut the strap while it is under tension because this action
can result in injury or damage.
Before placing the device onto the mounting surface (asset), ensure
that the safety lanyards which are provided are attached and secured
to prevent the device falling from heights potentially causing injury.
10
October 2023
Emerson.com/Rosemount