General And Control Panel Cleaning; Operating Anomalies / Failures; Maintenance To Be Carried Out By The Expert Technician - Ferroli EGEA TECH 200 HT Manual

EGEA TECH
Do not remove the plug from the
socket by pulling the power cord.
DANGER

3.2.1 General and control panel cleaning

Periodicity:
MONTHLY
(or in conditions of
USER
evident dirt)
Do not pour or spray water on the
product.
Do not clean the surfaces with
PROHIBITION
easily flammable substances (for
example: alcohol or paint thin­
ners).
Clean only the external surface
and the control panel using a
soft, dry cloth.
MANUAL
CLEANING

3.2.2 Operating anomalies / failures

In case of operating anomalies, possible failures or replace-
ment of parts due to wear/damage, the user must:
• switch off the water heater as indicated in the section
"Switching off" in paragraph 3.5 and disconnect the power
cord plug from the socket.
• Contact an expert technician or the technical assistance
service.
3.3 MAINTENANCE TO BE CARRIED OUT BY THE
EXPERT TECHNICIAN
Any
equipment must be performed
by qualified personnel. Exclu­
sively for interventions on the
refrigeration circuit, including
disposal, the personnel must
be equipped with a suitable re­
EXPERT TECHNICIAN
frigeration technician's licen­
se aimed at the knowledge and
management of systems con­
taining gases of the HFC type.
200 HT - 260 HT
Equipment to be
used
Soft and dry cloth
intervention on
cod. 3540000420 - Rev. 03 - 09/2023
CHECK OF THE DEVICE
USER
To ensure the functionality and efficiency of the device, it must
be subjected to regular checks.
• Refer to chapter 10.
TROUBLESHOOTING / REPLACEMENT / MAINTENANCE
USER
Before carrying out any type of intervention on the device, the
personnel in charge of maintenance must refer to what is re-
ported in this manual in the following chapters and in particular
to consult chapter "10. REQUIREMENTS FOR THE OPERA-
TION, SERVICE AND INSTALLATION" on page 184.
ATTENTION
ATTENTION
the
EXPERT TECHNICIAN
/ MANUFACTURER'S
TECHNICAL
ASSISTANCE
EXPERT TECHNICIAN
/ MANUFACTURER'S
TECHNICAL
ASSISTANCE
The manufacturer cannot be held
responsible for
carried out by non­expert and
non­qualified personnel.
DO NOT TAMPER WITH THE
POWER CORD.
If the power supply cable is dam­
aged, it must be replaced by the
manufacturer or the technical as­
sistance service or in any case
by a person with similar qualifi­
cations, in order to prevent any
risk.
EN
Periodicity:
YEARLY
Periodicity:
IN CASE OF
ANOMALY OR
FAULTS.
interventions
139