Operating Instructions; Introduction; Control Panel - Ferroli BLUEHELIX PRO RRT 32 C Instructions For Use, Installation And Maintenence

Table of Contents

Advertisement

1. Operating instructions

1.1 Introduction

Dear Customer,
BLUEHELIX PRO RRT 32 C is a high-efficiency, low emissions premix condensing heat generator with a stainless
steel heat exchanger and incorporated DHW production, using natural gas or LPG and equipped with a microprocessor
control system.
The sealed chamber unit is designed for indoor installation with temperatures as low as -5°C (-15°C with optional anti-
freeze kit).

1.2 Control panel

10
5
8
4
3
13
7
14a
fig. 1- Control panel
Panel legend fig. 1
1
DHW temperature setting decrease button
2
DHW temperature setting increase button
Indication during operation
Heating
A heating demand (generated by the Room Thermo-
stat or Remote Timer Control) is indicated by the acti-
vation of the radiator symbol (detail 13 - fig. 1).
The display (detail 12 - fig. 1) shows the actual heating
flow temperature and after the heating demand a standby
or delay time message "d2" appears (see fig 2).
Domestic hot water (DHW)
A DHW demand (generated by drawing hot water) is indicat-
ed by the activation of the tap symbol (detail 9 - fig 1).
The display (detail 12 - fig. 1) shows the actual DHW
outlet temperature and after the DHW a standby or de-
lay time message "d1" appears (see fig 3.).
4
12
17
2
1
14b
6
9
cod. 3541T030 - Rev. 00 - 10/2019
BLUEHELIX PRO RRT 32 C
3
Heating system temperature setting decrease button
4
Heating system temperature setting increase button
5
Display
6
Reset button - Outside Temperature Compensation
7
Mode selection button: "Winter", "Summer",
"Unit OFF", "ECO", "COMFORT"
8
Eco (Economy) or Comfort mode
9
DHW demand
10
Summer mode
12
Multifunction display (flashing during exchanger
protection function)
13
Heating demand
14a Burner lit (flashing during calibration function
and self-diagnosis phases)
14b Appears when a fault has occurred causing the
unit to shut down. To restore unit operation,
press the RESET button (detail 6)
17
External sensor detected (with optional external
probe)
fig. 2
fig. 3
EN

Advertisement

Table of Contents
loading

This manual is also suitable for:

0t3b3iga

Table of Contents