Equipment Maintenance; Platform Plate Removal And Maintenance; Maintenance Of Screw Rod And Guide Rail - Creality CR-10 SE User Manual

7. Equipment Maintenance

7.1 Platform plate removal and maintenance

① a. When printing is finished, wait for the platform plate to cool
before removing the printing platform with the model attached;
b. Slightly bend the platform with both hands to separate the
model from the platform.
Tips: 1. Don't bend too much for daily use to prevent deformation and unusability;
2. The printing platform is a perishable part, and it is recommended to replace it regularly to ensure that the first layer of the model sticks properly.

7.2 Maintenance of screw rod and guide rail

Regularly lubricate and maintain the screw rod and guide rail areas with purchased lubricating grease.
Z-axis screw rod area
② If there are residual filaments on the
platform plate, scrape them off lightly
with a blade and print again.
X-axis and Y-axis guide rail areas
20
③ If the first layer of the model is not
properly glued, it is recommended
to apply solid adhesive evenly on
the surface of the platform plate
before preheating for printing.
above
front
under
X-axis guide rail area
above
right
left
Y-axis guide rail area