Equipment Wiring - Creality CR-10 SE User Manual

3. Assembly Procedure

3.5 Equipment Wiring

⑧ Connect the power cable
Z2-axis motor
Caution
Please ensure the correct position for the power supply switch and mains
●
before supply connection, in order to avoid damage to the device.
If the mains between 100V and 120V, please select the 115V for the power
●
supply switch.
If the mains between 200V and 240V, please select the 230V for the power
●
supply switch (default is 230V).
Extruder adapter board
X-axis motor
Y-axis motor
Z1-axis motor
① Connect the filament detection line;
③ Connect the X-axis motor wire;
⑤ Connect the Z1-axis motor wire;
⑦ Connect the filament detection
line and LED light cable;
07
② Follow the label instructions to first
insert the extruder cable into the cable
clamp, then connect the extruder cable;
④ Connect the Y-axis motor wire;
⑥ Connect the Z2-axis motor wire;
Z2-axis motor connector
LED light connector
Filament detector connector