Ruijie S8600E Series Hardware Installation page 12

Hardware Installation
Preparations
There is a ground bar in the installation environment
(recommended):
① Remove ground screws from the rear panel of the
chassis.
② Put the OT terminal of the ground cable delivered with
the device on the ground screws of the chassis.
③ Install the ground screws with the OT terminal to the
ground holes, fasten them with a screwdriver, and
connect the other end of the ground cable to the ground
bar of the equipment room (cut the ground cable to an
appropriate length).
There is no ground bar in the installation environment:
When there is no ground bar in the environment where the
device is to be installed and the device adopts AC power
supply, the PE cable of the power supply must be grounded.
Therefore, check whether the PE cable of the AC power
supply is properly grounded in the power distribution room or
on the AC transformer side.
Installing the Device
to a Specified
Position
Installing Power
Grounding Modules, Cards, and
Other Modules
Check and
Confirmation