Piping And Instrumentation Diagram - Salda RIRS H EKO 3.0 Mounting And Installation Instruction

•
• Before commencing the installation of the unit, please check if all ordered equipment have been delivered. Any variation from the ordered equip-
ment list must be reported to the product supplier.
5.4.

PIPING AND INSTRUMENTATION DIAGRAM

Figure 5.4.1. * KE1 - only in electrical version; * KV1 - used in water version; ** Possible to control.
THE LIST OF COMPONENTS
PV Supply air fan
PF
TE Exhaust air temperature sensor
DTJ Extract air temperature and humidity sensor
PC Computer
M2 Outdoor air damper actuator
TL Outdoor air temperature sensor
NET
R Rotor heat exchanger
KV1 Water heater*
M4 Water heater circulation pump*
RC2 Stouch, Flex or ST-SA-Control remote control panel
TV1 Water heater temperature sensor *
* Component/possibility to connect it depends on model.
POSSIBLE PCB INPUTS/OUTPUTS
FA Fire alarm
RIRS 400-700 H EKO 3.0 v2023.2
IF
IV Exhaust fan
TJ Supply air temperature sensor
CO CO sensor
2 2
KE1 Electric heater*
M3 Exhaust air damper actuator
Ventilated premises
MB-Gateway
DX DX cooler
T1 Water heater thermostat*
M5 Water cooler valve motor
M6 Water heater valve motor*
M1 Rotor motor
H1 Working indication output
H2 Alarm indication output
EN | 9