Table of Contents
Advertisement
3.
Remove the three Phillips PM2.0×4.0 screws (2) that secure the power button board to the
top cover.
4.
Remove the power button board and cable (3).
Reverse this procedure to install the power button board and cable.
Fingerprint reader board
Description
Fingerprint reader board (select models only, includes bracket, but does not include cable)
NOTE:
The fingerprint reader board cable is not included in the fingerprint reader board spare
part kit. The fingerprint reader board cable is included in the Cable Kit, spare part number
640422-001.
Before removing the fingerprint reader board, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
●
Optical drive (see
●
Hard drive (see
78
Chapter 4 Removal and replacement procedures
Battery on page
59), and then remove the following components:
Optical drive on page
Hard drive on page
62)
60)
Spare part number
640427-001
Advertisement
Table of Contents
