Table of Contents
Advertisement
TouchPad
Description
TouchPad (includes cable)
Before removing the TouchPad, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the service cover (see
a.
Battery (see
b.
Hard drive (see
c.
Keyboard (see
d.
Top cover (see
Remove the TouchPad:
1.
Turn the top cover upside down with the front toward you.
2.
Release the ZIF connector (1) to which the TouchPad cable is attached, and then disconnect the
TouchPad cable from the card reader board.
3.
Remove the two Philllips PM2.0×3.25 screws (2) that secure the TouchPad to the top cover.
4.
Remove the TouchPad and cable (3).
Reverse this procedure to install the TouchPad.
100 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Service cover on page
Battery on page
69)
Hard drive on page
71)
Keyboard on page
81)
Top cover on page
89)
67), and then remove the following components:
Spare part number
730549-001
Advertisement
Table of Contents
