C
3
HAPTER
CIM Port
The CIM ports require standard 8-pin modular jacks (RJ-45) consisting of 2 balanced signal pairs on a
Category 5 Universal Twisted Pair (UTP) crossover cable. The twisted pairs are arranged as: 1,2: 3,6;
4,5; 7,8. Each tied pair is connected to a 75 ohm resistor. The following table lists the signal for each pin.
CIM Port Pin Allocation
Table 3.11:
Pin Number
1
2
3
4
ASU II ONS Parameters
The ASU II ONS parameters are the same as those for the Analog Boards; please refer to
Circuit Impedance Values," on page
ASU and Universal ASU ONS Parameters
ONS Transmission Parameters
Transmission Parameters
Table 3.12:
ASU variant
NA
1
UK
2
LA
3
EU
1. The UK ASU is used in the United Kingdom and New Zealand.
2. The LA ASU is used in Latin America, including Brazil.
3. The EU ASU is used in Australia, France, German, Italy, Netherlands, Portugal, and Spain.
Signal
RX+
RX-
TX+
–
47.
Input Impedance
600 ohms
300 Ω+(1000 Ω||220nF)
600 ohms
270 Ω+(750 Ω||150nF)
Pin Number
5
6
7
8
Balance Impedance
600 ohms
300 Ω+(1000 Ω||220nF)
600 ohms
270 Ω+(750 Ω||150nF)
P
A
IN
LLOCATIONS
S
U
G
ERVICES
NITS AND
ATEWAYS
Signal
–
TX-
–
–
Table 18, "ONS
55