Bolin Controller Visca Over Ip Setup Overview - Bolin Technology D Series User Manual

Bolin Controller VISCA Over IP Setup Overview

o
Push the SETUP
o
Rotate the P/T SPEED
o
Push the P/T SPEED
o
Rotate the ZOOM SPEED
function.
o
Select EXIT on the
D
menu selection.
On the controller display
IP CONFIGURATION >TYPE: DHCP or STATIC IP can be selected,
and an IP address, subnet mask, and gateway number dialed in.
Note: The controller IP address must be within the same subnet as the Dante AV™ camera(s).
Scanning Dante AV™ Network for Available VISCA Over IP Camera(s)
o
Under CAMERA SETTINGS > PROTOCOL > VISCA IP should be selected.
o
Under KEYBOARD SETTING > VISCA IP SETTINGS > PORT 52381
Flo should be selected.
Note: Camera and controller should be set for Visca Over IP
o
Push the SEARCH button to bring up the Auto Search menu.
o
Move the cursor to VISCA-IP with the
o
Select Yes and push the
o
A list of discovered cameras will appear on the
o
Scroll through the discovered cameras using the
o
To add a camera to the Bolin controller (KBD-1010-RNV), press
the ADD button.
o
Assign each discovered camera a CAM ID # using the
o
Move the cursor to Title with the
keypad to give the selected camera a title.
o
Select EXIT to leave selection.
Controling your Camera(s) via VISCA Over IP
Once the controller and the camera(s) are set and ready (Visca-IP – OK), you can start using the
o
Bolin controller functions to control the camera(s).
o
To switch and control each camera independently, push the camera ID# on the alphanumeric keypad,
followed by the CAM button to select. The
Note: For more detail information about the Bolin controller go to:
button and enter the password (default 0000)
knob to move the cursor and select a function.
to make a selection / enter.
to change /save the setting(s) of a selected
controller display to go back or exit the display
under: KEYBOARD SETTING >
P/T SPEED
P/T SPEED knob to start the search
P/T SPEED
Alphanumeric Pad
knob
controller display
ZOOM SPEED dial.
ZOOM SPEED
knob, and use the alphanumeric
controller display section will then show the selected CAM (ID #).
Bolin KBD -1010-RNV User Guide
Joystick Controls
CAM Button
26
Knob.