Ethernet/Ip Configuration; Configuring Ethernet Interface; General Connectivity Settings - Danfoss EtherNet/IP iC7 Series Operating Manual

iC7 Series EtherNet/IP
Operating Guide

4 EtherNet/IP Configuration

4.1 Configuring Ethernet Interface

The X1 and X2 interfaces are internally connected with an Ethernet switch and share the same physical MAC layer, and the same IP
settings apply to both interfaces.
IPv4 settings are configured in MyDrive
1. Configure IPv4 settings.
- In MyDrive Insight, go to Setup and Service → Interface configuration → Interface X1/X2 → IPv4 settings.
®
- In the control panel, navigate to parameter group 10.2 Communication Interfaces.
Table 9: IPv4 Settings
Function
Interface X1/X2
MAC address
IPv4 addressing
method
Requested IPv4 ad-
dress
Requested IPv4
subnet mask
Requested IPv4
gateway address
Enable ACD
DNS server 1, 2

4.2 General Connectivity Settings

General connectivity settings are in parameter group 10 Connectivity → Integrated Communication → Protocols → General Settings.
Danfoss A/S © 2023.09
Insight or in the control panel.
®
Value Description
00:1B:08:xx:xx:xx The MAC address of interface X1/X2. The value is read-only.
Disable Only link-local IP address in the 169.254.xxx.xxx range is active.
Static IP A static IP address is entered manually.
Automatic IP address is assigned via a DHCP or BOOTP server.
xxx.xxx.xxx.xxx
If Automatic is selected as the IPv4 addressing method and no DHCP/
BOOTP server is present, the X1/X2 interface automatically configures an
IP address and subnet mask in the 169.254.xxx.xxx range.
xxx.xxx.xxx.xxx The requested IPv4 subnet mask for the interface.
xxx.xxx.xxx.xxx Requested IPv4 gateway address for the interface.
Enable/disable (de- Request to enable or disable Address Conflict Detection for the interface.
fault)
The change will not take effect before a power cycle is performed. If no
conflicts are detected, ACD activity displays 0. If an address conflict oc-
curs, the ACD activity displays 1, and the IPv4 interface will revert to an
automatically assigned IP address in the 169.254.xxx.xxx range.
xxx.xxx.xxx.xxx The user-requested Domain Name Server 1 for the interface (for manual
IP addressing mode only).
EtherNet/IP Configuration
AQ456329199699en-000101 / 136R0335 | 21