Table of Contents
Advertisement
7700 MultiFrame Manual
7712HDC HD Broadcast Quality Down Converter
Audio
Embedder A
Off
Follow A
Group 1
Group 2
Group 3
Group 4
6.9.
SETTING UP THE BROADCAST ANALOG OUTPUT PARAMETERS
(MODEL 7712HDC-SN-EAES4 ONLY)
The 7712HDC-SN-EAES4 version provides a broadcast analog output in addition to the standard SDI and
Monitor Analog outputs.
associated with the broadcast analog output. The menu is not available on the 7712HDC-S version. The
chart below shows the items available in the Broadcast Analog Output menu. Sections 6.9.1 to 6.9.7 give
detailed information about each of the parameters.
Composite Display
Output Level
Hue
Saturation
Contrast
Brightness
NTSC Setup Pedestal
Line 21 Setup Pedestal
6.9.1. Setting the Composite Display Mode – Colour or Monochrome
Broadcast Analog
Output
Composite display
Colour
B/W
7712HDC-28
With these controls, you can set the destination group for Embedder A and
B.
When set to Off, the embedder will be disabled.
When set to Follow A, or Follow B, the embedder destination will follow the
setting of the respective De-embedder. (See section 6.8.1)
Otherwise the embedder destination can be set to a specific group.
The group for Embedder A must be different from Embedder B. If the user
sets them the same then the next higher group number will be used for
Embedder B.
The Broadcast Analog Output menus are used to configure parameters
Controls whether the analog video output will be colour or monochrome.
Sets the analog video output level
Sets the analog video hue level
Sets the analog video saturation level
Sets the analog video contrast level
Sets the analog video brightness level
Sets whether the NTSC setup pedestal will be on the broadcast analog
video output
Sets whether the NTSC setup pedestal will be on line 21 on the broadcast
analog video output
If monochrome operation is desired on the composite output, colour may be
turned off with this control.
Revision 1.2
Advertisement
Table of Contents
