Function Setting; How To Enter Function Setting - LG PREMTTB101 Owners & Installation Manual

ENERGY
72
- Select On/Off on the detailed screen to set the target power consumption.
- When set to On, you can set the target power consumption (min 1 kWh, max 9,999 kWh).
After setting, press the [OK] button to save the set value.
- If you press the [Back] button without pressing the [OK] button, to move to the list screen
without saving the set value.
- On the Target System Energy Usage VER.2 screen, it's displayed with Last year's usage.
NOTE
!
• The displayed value is the power consumption for the entire system.
• If a target consumption that is much smaller than the daily average amount of power
consumed over the past 30 days is set, the target consumption may be exceeded.
The target power setting can be reached if it falls between approximately 50% to 100% of
the average amount of power consumed over the past 30 days. (0 to 50% based on the
savings rate)
Example) If the average daily amount of power consumed is 100 kWh, the savings may not
be more than 50 kWh even if 20 kWh is set as the power consumption target.
We do not recommend setting a target consumption of less than 50% of the
average daily amount of power consumed.
• There may be some difference between the actual usage, so use it only as a reference.
• Setting too small a target as the desired level of power consumption for the system may
result in poor cooling/heating performance.
• When setting the Target System Energy Usage function in the central controller, the
Setting Target energy usage and Setting System Target Energy Usage function of the
wired remote controller cannot be used.
• If a model for both cooling/heating, the Target System Energy Usage function is not
available during simultaneous cooling and heating operation.
• The configuration of the screen displayed may vary depending on the version of the remote
control and the connected product.

FUNCTION SETTING

How to enter function setting

To enter the menu displayed at the bottom, you need to enter the function setting menu as
follows.
• In the menu screen, press [<,>(left/right)] button to select the setting category, and press [OK]
button to move to the setting list.
• In the setting list, select the function setting category, and press [OK] button to move to the
function setting list.
FUNCTION SETTING
73
OK