Table of Contents
Advertisement
"General Info" Sub-Pages
See
2-46. Use page 1 to view generator status,
Figure
serial number, and run hours.
General Info
Generator:
Serial No:
Run Hours
Figure 2-46. General Info (Page 1)
See
Figure
2-47. Use page 2 to view battery condition.
General Info
Battery Condition:
Figure 2-47. General Info (Page 2)
See
Figure
2-48. Use page 3 to view the currently
installed versions of hardware, bootloader, firmware, and
firmware build.
General Info
Hardware
Bootloader
Firmware
Firmware Build
Figure 2-48. General Info (Page 3)
Technical Manual Power Zone 410 Controller
NOT ACTIVATED
SERVICE UNIT
xxx:xxh:m
013020
CHECK BATTERY
013021
V
x.xx
V
x.xx
V
x.xx
xxxx
013022
See
Figure
2-49. Use page 4 to view the currently
installed versions of the ECU (Engine Control Unit) and
EEPROM (Electronically Erasable Programmable Read-
only Memory).
General Info:
ECU
EEPROM
Figure 2-49. General Info (Page 4)
See
Figure
2-50. Use page 5 to view the currently
installed versions of I/O Extender hardware and firm-
ware.
General Info:
I/O Ext. 1
I/O Ext.
2
I/O Ext.
3
I/O Ext.
4
Figure 2-50. General Info (Page 5)
Alarm Screen
See
Figure
2-51. The Alarm Screen contains information
for viewing only. Use the navigation arrows (
scroll through alarms. Press STOP (
ENTER (
) while on the Alarm Screen to clear all
alarms present.
FT
ECODE
A
2801
W
2710
M
Battery Maint Due
Figure 2-51. Alarm Screen (Page 1)
General Information
V
x.xx
V
x
013023
HW
FW
V
xxxx
xxxx
V
xxxx
xxxx
V
xxxx
xxxx
V
xxxx
xxxx
013024
) and then
Active Fault
Aux Shutdown
Ruptured Tank
013025
) to
17
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Power Zone 410 and is the answer not in the manual?
Questions and answers
How to reset after it codes
To reset the Generac Power Systems Power Zone 410 after it shows a code, follow these steps:
1. Identify the Code – Check the displayed fault code to understand the issue.
2. Resolve the Issue – Address the underlying problem, such as fuel pressure issues or internal faults.
3. Reboot the Controller – Some faults, like watchdog timeouts or exceptions, trigger an automatic reboot.
4. Manually Reset if Needed – If the controller does not reset automatically, power cycle the system by turning it off and on.
5. Re-enter Activation Code – If prompted, enter the correct activation code within three attempts.
6. System Update – If the issue persists due to a software problem, complete the system update process.
If the issue remains unresolved, contact an IASD (Independent Authorized Service Dealer).
This answer is automatically generated