Table of Contents
Advertisement
General Information
Starting and Stopping Sequence Dia-
grams
NOTE: Shutdown Alarms will cause the engine to turn off
or not start.
Remote start
accept limits?
timer expired?
accept signal
Remote start
contacts OPEN?
timer expired?
Figure 2-1. 2-Wire Starting and Stopping Sequence Key
Switch in AUTO Position
NOTE: A Remote Start signal will terminate exercise and
proceed to normal running mode.
8
NO
contacts
CLOSED?
Start the
Engine
NO
At load
NO
Warm up
Issue Load
NO
NO
Cool down
Stop the
Engine
Figure 2-2. Exercise without Transfer Starting and Stopping
Sequence Key Switch in AUTO Position
NOTE: Shutdown Alarms will cause the engine to turn off
or not start.
Controller
The controller consists of an LCD display and buttons to
navigate through screens, make selections, and start or
stop the generator as shown in
A
B
C
012976
Figure 2-3. Front Panel Display
A
B
C
D
E
F
G
H
J
NO
Time to
exercise?
Start the
Engine
NO
Exercise time
expired?
Stop the
Engine
Figure
2-3.
AUXILIARY SHUTDOWN
F
G
H
D
E
AUTO mode
STOP mode
MANUAL mode
Navigation arrows
ESCAPE
ENTER
SILENCE
Auxiliary shutdown
USB port and 7.5 A fuse
Technical Manual Power Zone 410 Controller
012977
J
012975
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Power Zone 410 and is the answer not in the manual?
Questions and answers
How to reset after it codes
To reset the Generac Power Systems Power Zone 410 after it shows a code, follow these steps:
1. Identify the Code – Check the displayed fault code to understand the issue.
2. Resolve the Issue – Address the underlying problem, such as fuel pressure issues or internal faults.
3. Reboot the Controller – Some faults, like watchdog timeouts or exceptions, trigger an automatic reboot.
4. Manually Reset if Needed – If the controller does not reset automatically, power cycle the system by turning it off and on.
5. Re-enter Activation Code – If prompted, enter the correct activation code within three attempts.
6. System Update – If the issue persists due to a software problem, complete the system update process.
If the issue remains unresolved, contact an IASD (Independent Authorized Service Dealer).
This answer is automatically generated