Installing The Transducer On A Drop Keel - Kongsberg EK80 Reference Manual

Installing the transducer on a drop keel

The transducers you want to use with the EK80 system must be "installed" as a part of the
software configuration. Transducer(s) in the drop keel are supported. Which transducers
to use depends on the number of transceivers in your system, and the licenses you have
for these.
Prerequisites
It is assumed that the EK80 software has been installed, and that all relevant license strings
have been applied. You need to know the type and serial number of each transducer that
you wish to install.
Context
Each transducer is added using the
page is located in the
You can only choose a transducer from the
a system file provided with the EK80 software. It contains all the transducers that
are compatible with the transceiver(s) you have. The list also includes the technical
specifications for each transducer. You cannot see this information, but it is used to set
up the operating parameters This allows each transceiver to optimise its performance for
the individual transducer models.
If you cannot find your transducer in the list, contact you dealer, agent or Kongsberg
Maritime to upgrade the relevant software component.
Note
Just making changes and selecting
Select what to install, define the relevant parameters, and then select
Procedure
1 Open the
Setup
2 On the menu, select
Setup
Observe that the
pages selected from the menu on the left side.
3 On the left side of the
395234/J
Transducer Installation
dialog box.
Installation
at the bottom of the page will not install anything.
OK
menu.
Installation
dialog box opens. This dialog box contains a number of
Installation
dialog box, select
Installation
page. The
list. The
Model Model
.
Transducer Installation
Operating procedures
Transducer Installation
list is generated from
.
Add
.
321