Kongsberg EK80 Reference Manual page 326

Note
This is a critical task. Make sure that the correct transducer is selected.
c At the bottom of the page, select
d Observe that the status for the relevant frequency channels change to Installed.
Tip
If no transceivers are listed:
1 Select in the
Browse
2 Select the correct address for the Ethernet adapter you are using. Select
This will make the EK80 search the network for available transceivers.
3 Turn each transceiver off and on.
The EK80 system automatically assigns an IP address to a transceiver that is turned
off and on.
Select .
Browse
4 Make sure that the Ethernet communication between the units is operational.
5 If you are using an Ethernet switch, make sure that it works.
6 If you have changed the network settings, turn each transceiver off and on.
The EK80 system automatically assigns an IP address to a transceiver that is turned
off and on.
4 At the bottom of the page, select
5 Repeat until all the channels have been installed.
6 Continue your work in the
Result
When all channels have been installed, you can start normal operation.
Related topics
Installing transducers and transceiver channels in the user interface, page 313
395234/J
Apply
Transceiver Browsing
to save your settings.
Apply
dialog box, or select
Installation
to save your settings.
box, and open the
Local IP Address
OK
Operating procedures
box.
.
Apply
to close it.
325