Kongsberg EK80 Reference Manual page 82

Note
The information shown in your information panes only reflect the echo data from the
currently "active" layer.
If you wish your information panes to show data from the entire water column, you must
either click "outside" the layer(s) in your echogram to deselect all of them. This will
"activate" the default background layer. Another option is to simply delete all the layers.
• Once a depth layer has been made you can change its properties using the
dialog box. If you only wish to change the range settings, you can also click
Properties
and drag the line(s) in the echogram view. The lines in the echogram will reflect the
changes you make, but these will disappear to the left after some time. Observe that
vertical lines are drawn in the echogram to identify the start of each calculation interval.
The
Layer Properties
• A single layer can be deleted if you do not need it any longer. To delete a layer, select it
in the echogram or in the Numerical information field (layer data shown with red text),
and then click
Delete Layer
• When you record raw data, the layers you have defined are not included. This means
that you can also use the layer functionality during replay.
• Each of the depth layers can be used to measure the background (ambient) noise in
the water column.
• The Numerical information pane is the best tool for controlling your depth layers.
All layers are listed, even those that may be located outside your current echogram
presentation. The different layers can easily be activated by clicking the list of numerical
data.
Related topics
User interface introduction, page 67
395234/J
dialog box is located on the
. The
Delete Layer
menu.
Active
function is located on the
Getting started
Layer
menu.
Active
81