Attaching The Leg Support Brackets To The Extension Table - SawStop TSG-FDC Owner's Manual

Insert a Bolt - M6 x 1.0, 16mm, Hex
2
Head [Q] through the hole in the
Leg Support Bracket [D] and then
through the tab of the Upper Leg
[C], followed by a Lock Washer –
M6 [P] and a Lock Nut - M6 x 1.0
(U). The nut should be only finger
tight at this time.
Repeat steps 1-2 to attach the
3
second Leg Support Bracket [D]
to the exterior side of the rear tab,
making sure the bent sections of
the leg support bracket and the leg
support mounting bracket face out
toward the rear of the saw.
The nut should be only finger tight at
this time.

Attaching the Leg Support Brackets to the Extension Table

Pivot the bent end (with the eye
1
bolt assembly) of the front Leg
Support Bracket [D] up toward the
underside of the wooden extension
table support frame.
Rotate the L Bracket – Leg
2
Support [O] and/or Eye Bolt -
10.5mm, M5X1.0, 80mm [N] until
the flat side of the L Bracket –
Leg Support [O] is flush with the
outer portion of the extension table
support frame.
11
TSG-FDC OWNER'S MANUAL
O
N
U P
Q
D
REAR TAB
D
D
EXTENSION TABLE
SUPPORT FRAME