Table of Contents
Advertisement
Secure the button head socket
3
screw in place with a Lock Nut - M6
x 1.0 (U), using a 4mm Allen wrench
and a 10mm wrench.
Lock the floating blade guard in
4
its upper, retracted position. To
do this, loosen the floating guard
lock handle and lift the clear hood
portion up towards the inner dust
tube. When the Floating Blade
Guard (I) is in its upper position,
re-tighten the floating guard lock
handle.
Loosen the inner dust tube lock
5
knob and extend or retract the
Inner Dust Tube (G) to center the
Floating Blade Guard (I) over the
blade. Then re-tighten the inner dust
tube lock knob to secure the inner
dust tube and floating blade guard.
IT IS RECOMMENDED THAT THE FLOATING BLADE GUARD ALWAYS BE
LOCKED IN ITS UPPER POSITION BEFORE THE DUST TUBES ARE MOVED
OR PIVOTED.
For bevel cuts, where the blade is tilted to the left, you may need to move the Floating Blade
Guard (I) to the left so it does not interfere with the teeth on the saw blade. First, turn off your saw
i
and lock the floating blade guard in the upper, retracted position. Then, position the saw blade at
the desired angle and elevation. Carefully lower the guard and telescope the Inner Dust Tube (G)
further to the left side of the saw as necessary, checking the clearance between the sides of the
guard and the teeth on the blade.
ALWAYS CHECK THE POSITION OF THE FLOATING BLADE GUARD (I)
PRIOR TO BEGINNING ANY CUTS, TO MAKE SURE IT WILL NOT
INTERFERE WITH THE TEETH ON THE SAW BLADE.
LOCK HANDLE
I
G
DUST TUBE LOCK KNOB
I
TSG-FDC OWNER'S MANUAL
U
16
Advertisement
Table of Contents
