Table of Contents
Advertisement
Install the Limit Bolt and Adjust the Dust Tube Lock Knob Tension
Insert and adjust the limit bolt and
1
nut as follows:
Thread the Nut - M8 x 1.25 [T]
onto the Bolt - M8 x 1.25, 45mm,
Hex Head [V] about 1/3 of the
way down the shaft for now. Next,
thread the through the Bolt - M8 x
1.25, 45mm, Hex Head [V] into the
mounting bracket as shown.
Adjust the nut and bolt to tune
the positioning of the dust tube
assembly such that the Floating
Blade Guard [I] aligns with (over)
the blade. Additionally, the bolt head
should contact the Dust Collection
Guard Mounting Bracket [B] and
act as a stop when alignment that
offers optimal dust collection is
achieved.
Continue with the dust tube
2
assembly positioned over the table
saw and it's flat plate portion of
Outer Dust Tube – Curved [E]
rests securely against the Dust
Collection Guard Mounting
Bracket [B].
Grasp the end of the Dust Tube
3
Lock Knob and pivot it towards the
dust tube assembly until the end
of the threaded portion of the lock
knob lines up with the depression
in the flat plate portion of Outer
Dust Tube – Curved [E] and push
it until it is over center past the
depression.
17
TSG-FDC OWNER'S MANUAL
V
E
E
DUST TUBE
LOCK KNOB
T
B
Advertisement
Table of Contents
