SawStop TSG-FDC Owner's Manual page 17

If you have a 36" extension table, rotate
the leg support mounting bracket (O) and/
i
or eye bolt (N) until the flat side of the leg
support mounting bracket is flush with
the cross support frame of the
extension table.
Make a mark on the underside of
3
the extension table support frame
in the center of the hole of the L
Bracket – Leg Support [O].
Pivot the leg support bracket back
4
down to rest on the floor. Drill a pilot
hole in the location you marked in
step 3 with a 7/64" drill bit. Be sure
to drill into the cross-support frame
if you have a 36" extension table.
Pivot the leg support bracket and
5
attached components up again
and align the leg support mounting
bracket hole with your drilled
pilot hole.
EXTENSION TABLE
CROSS SUPPORT FRAME
N
O
EXTENSION TABLE
CROSS SUPPORT FRAME
TSG-FDC OWNER'S MANUAL
O
EXTENSION TABLE
SUPPORT FRAME
12