Insert a single Bolt - M6 x 1.0,
8
40mm, Hex Head [K] through a
Flat Washer - M6, 20mm x 1mm
[Y] then through one of the four
exposed elongated holes in the
Dust Collection Guard Mounting
Bracket (B) and extension table.
Next add a second Flat Washer -
M6, 20mm x 1mm [Y] followed a
Nut - M6 x 1.0 [L] to the bolt at the
extension table facing side.
The nut should be only finger tight at
this time.
Repeat step 8 for the remaining
9
three elongated holes in the
mounting bracket assembly and
extension table.
Confirm that the dust collection
10
guard mounting bracket is still
positioned correctly against the
extension. If the position needs
to be adjusted, make use of
the clearance afforded by the
elongated slots.
Y
K
Y
L
TSG-FDC OWNER'S MANUAL
B
8