Table of Contents
Advertisement
Insert a Screw - M5 x 2.1, 32mm,
6
Button Head, Phillips [S] through a
Flat Washer - M5, 12mm x 0.8mm
[R] and then through the exposed
hole in the L Bracket – Leg
Support [O]. Secure the bracket
to the underside of the extension
table support frame using a Phillips
screwdriver or drill.
Repeat steps 1-6 for the rear leg
7
support mounting bracket.
Check to make sure the Extension
8
Leg [A] is still vertical and make any
necessary adjustments.
Use a 10mm wrench to tighten the
9
six Lock Nut - M6 x 1.0 [U] on the
eye bolts for the front and rear Leg
Support Brackets [D].
Adjust the position of the first lock
nut on the shaft of the eye bolt if
needed to achieve ample tension to
support the assembly.
13
TSG-FDC OWNER'S MANUAL
O
R
S
U
Advertisement
Table of Contents
