Assembly Instructions; Attaching The Upper Leg And Leg Support To The Dust Collection Mounting Bracket - SawStop TSG-FDC Owner's Manual

ASSEMBLY INSTRUCTIONS

Attaching the Upper Leg and Leg Support to the Dust Collection Mounting Bracket

Insert the Upper Leg [C] into the
1
Dust Collection Guard Mounting
Bracket [B] while ensuring that the
pair of holes in each piece align.
Secure C and B with hardware
described in Step 2.
Add a Flat Washer - M8, 17mm x
2
2mm [X] to the Bolt - M8 x 1.25,
60mm, Hex Head [BB].
Insert the bolt into the lower hole
of the Dust Collection Guard
Mounting Bracket [B] then add
another Flat Washer - M8, 17mm
x 2mm [X] onto the end of the bolt.
Next, stack on a Lock Washer - M8
[Z] and finally a Nut - M8 x 1.25 [T].
Using a 13mm wrench at both the
nut and bolt, tighten the nut to
secure the Upper Leg [C] into the
Dust Collection Guard Mounting
Bracket [B].
Slide the hollow end (the end
3
without the cap) of the Extension
Leg [A] into the Upper Leg [C]
C
T
Z
X
(Mounting Bracket)
BB
C
A
TSG-FDC OWNER'S MANUAL
PAGES:
4-19
B
BB
X
B
C
4