Connecting to a Dust Collection System
CONNECT YOUR FLOATING DUST COLLECTION GUARD TO A DUST
COLLECTION SYSTEM BEFORE STARTING YOUR TABLE SAW.
Using a 4" hose (not included) and a
1
hose clamp (not included), connect
the base of the Outer Dust Tube
- Curved [E] to a dust collection
system.
Make sure that both ends of the
dust hose are securely connected
and tightly sealed.
ALWAYS TURN THE DUST COLLECTION SYSTEM ON BEFORE STARTING
YOUR TABLE SAW, AND TURN THE DUST COLLECTION SYSTEM OFF
AFTER STOPPING YOUR TABLE SAW.
ADJUSTING YOUR
FLOATING DUST COLLECTION GUARD
Adjusting the Dust Tube Parallelism
If the dust tubes are not parallel with
1
the front and back of the table, the
parallelism will need to be adjusted.
Ensure the floating blade guard is
locked in its retracted position. Next,
release the dust tube lock knob and
pivot the dust tubes towards the
rear of the table.
19
TSG-FDC OWNER'S MANUAL
E
PAGES:
19-22