Table of Contents
Advertisement
Thread a Lock Nut - M6 x 1.0 [U]
3
about half way up the shaft of each
eye bolt [N].
Insert the shaft of an Eye Bolt -
4
10.5mm, M5X1.0, 80mm [N] as
shown through the hole in the bent
end of a Leg Support Bracket [D],
followed by a Lock Washer – M6
(P) and a Lock Nut - M6 x 1.0 [U].
The nut should be only finger tight at
this time.
Repeat step 4 for the second Leg
5
Support Bracket [D].
Attaching the Leg Support Brackets to the
Dust Collection Guard Mounting Bracket
Place the flat, non-bent end of a
1
Leg Support Bracket [D] against
the exterior side of the front tab
welded to the Upper Leg [C]. Make
sure the bent sections of the Leg
Support Bracket [D] and the L
Bracket – Leg Support [O] face out
toward the front of the saw.
N
U
N
D
P
U
FRONT TAB
D
O
TSG-FDC OWNER'S MANUAL
C
D
10
Advertisement
Table of Contents
