SawStop TSG-FDC Owner's Manual page 12

Locate an additional mark using
4
the upper round hole where the
Upper Leg [C] is joined to the
Dust Collection Guard Mounting
Bracket [B] to locate the mark.
Set the dust collection guard
mounting bracket and extension leg
assembly aside.
Using a 1/4" drill bit, drill four
5
through-holes in the extension table
at the locations marked in step 3.
Use a 5/16" drill bit to drill one
6
additional hole at the location you
marked in step 4.
Add a Flat Washer - M8, 17mm x
7
2mm [X] onto the Bolt - M8 x 1.25,
80mm, Hex Head [CC].
Next, with the newly drilled
mounting holes of the extension
table aligned with the Dust
Collection Guard Mounting
Bracket assembly, insert the bolt
[CC] through the upper round hole
where the Upper Leg [C] is joined
to the Dust Collection Guard
Mounting Bracket [B] and through
the drilled hole in the extension
table.
Next add Flat Washer - M8,
17mm x 2mm [X] followed by Lock
Washer - M8 [Z] followed by Nut
- M8 x 1.25, [T] to the bolt at the
extension table facing side.
The nut should be only finger tight at
this time.
7
TSG-FDC OWNER'S MANUAL
C
B
X
Z
AA
X
T
Z
VIEW UNDER TABLE