Attaching The Floating Blade Guard To The Dust Tube - SawStop TSG-FDC Owner's Manual

With the help of another person, lift
3
the dust tube assembly (comprised
of the inner and outer dust tubes
[E, F, G]) and set them on the dust
collection guard mounting bracket.
Be sure that the pins (indicated
by the red arrows) on the Dust
Collection Guard Mounting
Bracket [B] pass through the holes
in the bracket on the outer dust tube
(indicated by the yellow circles).

Attaching the Floating Blade Guard to the Dust Tube

Slide the Floating Blade Guard (I)
1
onto the end of the Inner Dust Tube
(G) until about 1" of the inner dust
tube extends past the floating blade
guard.
Slide a Bolt - M6 x 1.0, 40mm Hex
2
Head (K) through the two holes in
the clamping portion of the Floating
Blade Guard (I), with the threaded
portion of the bolt facing towards
the front of the floating blade guard.
It may be useful to loosen the spring
i
tension knob on the rear side of the
clamping portion of the floating blade
guard so the spring can be pushed out of
the way.
15
TSG-FDC OWNER'S MANUAL
B
G
1"
I
I
K