Table of Contents
Advertisement
Loosen the Nut - M8 x 1.25 [T]
2
using a 13mm wrench and thread
the Bolt - M8 x 1.25, 45mm, Hex
Head [V] in or out relative to the
dust collection guard mounting
bracket. Once the bolt is in the
correct position, use a 13mm
wrench to re-tighten the nut in order
to secure the bolt.
Adjusting the Dust Tube Length
Loosen the inner dust tube lock
1
knob by turning the handle counter-
clockwise and slide the inner dust
tube in or out of the outer dust tube
until the desired position of the
floating blade guard is reached.
Tighten the inner dust tube
2
lock knob by turning the handle
clockwise. Do not over-tighten the
inner dust tube lock knob.
T
V
TSG-FDC OWNER'S MANUAL
20
Advertisement
Table of Contents
