Table of Contents
Advertisement
Using a 10mm wrench on the
11
head of each of the four M6 bolts
and a 10mm wrench on each nut,
tighten the nuts to secure the dust
collection guard mounting bracket
to the extension table.
Using a 13mm wrench on the head
of the M8 bolt and a 13mm wrench
on its nut that you placed in step
8, tighten the nut to further secure
the dust collection guard mounting
bracket to the extension table.
Confirm that the Extension Leg [A]
12
is vertical. If necessary, adjust the
extension leg lock knobs and/or the
bolts attaching the dust collection
guard mounting bracket to the
extension table.
Assembling the Leg Support Brackets
Insert a Bolt - M6 x 1.0, 18mm, Flat
1
Head, Socket [M] through the eye
of an Eye Bolt - 10.5mm, M5X1.0,
80mm [N], and then through one
of the holes in L Bracket – Leg
Support [O]. Next, place a Lock
Washer – M6 [P] onto the bolt,
followed by a Lock Nut - M6 x 1.0
[U]. The nut should be only finger
tight at this time.
Repeat Step 1 process for the
2
second eye bolt and L bracket.
9
TSG-FDC OWNER'S MANUAL
M
N
O
P
U
Advertisement
Table of Contents
