Attaching The Dust Collection Guard Mounting Bracket To The Extension Table - SawStop TSG-FDC Owner's Manual

Adjust the overlap between the
4
Extension Leg [A] and the Upper
Leg [C] until the total length of the
assembly (top of the dust collection
guard mounting bracket to the end
of the extension leg) approximates
height of the extension table of your
saw from the floor.
Thread the two Knob – M6,
5
Extension Leg Lock [DD] into the
two nuts on the Upper Leg [C]. The
knobs need only be moderately
snug at this time.
Upon completion of the installation
of your TSG-FDC, tighten the
extension leg lock knobs evenly to
secure the extension leg.
The knobs should engage the
Extension Leg [A] and secure it
against further movement. This will
help prevent potential injury due
to unexpected movement of the
floating dust collection guard.

Attaching the Dust Collection Guard Mounting Bracket to the Extension Table

Place the flat edge of the Dust
1
Collection Guard Mounting
Bracket [B] against the right edge
of the extension table on your saw.
Ensure the top of the bracket is
flush or just below flush with the top
of the extension table.
5
TSG-FDC OWNER'S MANUAL
A C
HEIGHT OF YOUR EXTENSION TABLE
DD
C
B