Mounting Without Mounting Rail - Siemens SIMATIC ET 200eco PN M12-L System Manual

Mounting

6.2 Mounting without mounting rail

Configuration variants
There are two mounting variants:
• Without mounting rail
• With mounting rail
You can find additional information in the following sections.
6.2 Mounting without mounting rail
Introduction
The ET 200eco PN M12‑L distributed I/O devices are designed for installation on a level, firm
surface.
The axially symmetric drill holes allow you to fasten the I/O devices to an aluminum or carrier
profile.
The following picture shows an aluminum mounting rail on which the I/O devices can be
mounted.
Figure 6-1 Aluminum profile
Required tools
For the installation you need a screwdriver, suitable for the screws used.
Required screws
For mounting, use screws with a diameter of 5 mm and a length of at least 35 mm.
40
Distributed I/O system ET 200eco PN M12-L
System Manual, 11/2023, A5E48753295-AG