Operation - LOGICDATA DMIclassic Series Operating Manual

DMICLASSIC FAMILY - OPERATING MANUAL // PAGE 22
20 Motor short circuit and/or open load
21 Firmware Error
22 Power Unit overload
23 Motor Under Voltage
28 External Collission Sensor Error
NOTICE
Do not operate the DYNAMIC MOTION system if problems persist. Contact
LOGICDATA for further information.

8 OPERATION

Instructions for operating the system can be found in the DYNAMIC MOTION System Manual. A list of core
features can be found below. Handset Keys are represented as follows for further description:
UP Key
DOWN Key
SAVE Key (DMIclassic C only)
1
Memory Position Key 1 (DMIclassic C only)
2
Memory Position Key 2 (DMIclassic C only)
3
Memory Position Key 3 (DMIclassic C only)
4
Memory Position Key 4 (DMIclassic C only)
Contact LOGICDATA.
Disconnect the Power Unit from the
Mains. Then, disconnect System from the
Power Unit. Reconnect the system again,
then operate the DM System as normal.
Release all Keys and wait for 5 seconds.
Then, try again.
Release all Keys and wait for 5 seconds.
Then, try again.
Disconnect the Power Unit from the
Mains and check cable connections.