Adjusting The Table To A Memory Position (Dmiclassic C Only) - LOGICDATA DMIclassic Series Operating Manual

DMICLASSIC FAMILY - OPERATING MANUAL // PAGE 24
8.3 ADJUSTING THE TABLE TO A MEMORY POSITION
(DMICLASSIC C ONLY)
Version A (without double-click function):
2
1. Press and hold the required Memory Position Key (e.g. 2).
▸ The Table Top will move until the saved Table Top height has been reached. If
you release the Key before the Memory Position is reached, the table will stop.
2
2. Release the Memory Position Key
7 3
▸ The display shows the Table Top height (e.g. 73 cm)
Version B (Auto-Movement with double-click function):
INFO
The double-click function is available only for DM Systems sold in US markets.
INFO
If you press any Key while the table moves to a Memory Position, the Table Top will stop
moving immediately. To continue, you must select the Memory Position again.
WARNING Risk of minor or moderate injury through unauthorized modifications
The control system firmware is supplied in Europe with the double-click function disa-
bled. After enabling this functionality the safety of the end product must be evaluated.
• A risk assessment to demonstrate conformity to the requirements of Machinery
Directive 2006/42/EC is required prior to use.
• LOGICDATA is not liable for injuries or damage caused by activating the double-
click function
2
1. Double-click the required Memory Position Key (e.g. 2)
▸ The table will move to the Memory Position. You do not have to hold the Key
7 3
▸ The display shows the Table Top height (e.g. 73 cm)