System Information; Dmiclassic B - LOGICDATA DMIclassic Series Operating Manual

DMICLASSIC FAMILY - OPERATING MANUAL // PAGE 19

7 SYSTEM INFORMATION

7.1

DMICLASSIC B

When a DMIclassic B Handset is installed alongside the DYNAMIC MOTION system, system information is
communicated via flashes of the LED Signal Light. Possible signals are as follows:
SIGNAL MESSAGE
No Light System operating normally
System not connected properly
Red Light Blinking System Error Warning
Green Light Blinking System Start-up
Reset in Progress
Duty Cycle Exceeded
Collision Detected (ISP)
Green Light Flashing Position Reset Required.
Rapidly
NOTICE
Do not operate the DYNAMIC MOTION system if problems persist. Contact
LOGICDATA for further information.
REQUIRED ACTIONS
Operate the DM System as normal
See Chapter 4 for connection instructions
Release all keys and wait for 5 seconds.
Then try to repeat the action again.
Disconnect all components from the
Power Hub.
Disconnect the Power Hub from the
Mains. Check the Power Hub for overhea-
ting. Let cool if necessary.
Check all cable connections and recon-
nect the system.
If problem persists: Perform a Position
Reset Procedure (Chapter 4.7).
Contact LOGICDATA.
Wait until the LED has stopped blinking
to continue. Do no press any buttons.
Remove the obstruction from the Table
System. Remove unnecessary loads from
the Table Top. Operate the DM System as
normal.
Perform a Position Reset Procedure
(System Manual, Chapter 4.7).