Assembly; Safety During Assembly - LOGICDATA DMIclassic Series Operating Manual

DMICLASSIC FAMILY - OPERATING MANUAL // PAGE 17

6 ASSEMBLY

This chapter describes the process of installing the DMIclassic Family handset into the DYNAMIC MOTION
System.
6.1

SAFETY DURING ASSEMBLY

WARNING Risk of death or serious injury through electric shocks
DMIclassic Family handsets are electrical devices. Basic safety precautions must be
taken at all times. Failure to observe electrical safety precautions may lead to death or
serious injury through electric shocks.
• Never open the Handset
• Ensure that the Handset is not connected to the Power Unit during assembly
• Do not convert or modify the Handset in any way
• Check the housing and cables of the Handset for visible damage. Do not install or
operate damaged products.
CAUTION Risk of minor or moderate injury through improper handling
Improper handling of the product during assembly may lead to minor or moderate
injury through cutting, pinching, and crushing.
• Avoid contact with sharp edges
• Be careful while handling tools that may cause personal injury
• Ensure assembly complies with the generally accepted standards and guidelines of
electrical engineering and furniture manufacturing
• Read all instructions and safety advice carefully
CAUTION Risk of minor or moderate injury through tripping
During assembly and operation, poorly routed Cables may become a trip hazard.
Tripping over Cables may lead to minor or moderate injury.
• Ensure that Cables are routed properly to avoid trip hazards
• Be careful not to trip over Cables when installing the Handset
NOTICE
Ensure proper ESD handling during assembly. Damage that can be attributed to elec-
trostatic discharge will void warranty claims.
NOTICE
To avoid damage to the product, measure the dimensions of the Handset before assembly.
NOTICE
Before assembly, all parts must be acclimatised to the ambient conditions.
NOTICE
Do not lift the Handset by its cable. This will cause irreparable damage to the product.
INFO
Perform a product risk assessment so that you can respond to potential residual ha-
zards. Assembly instructions must be included in your end user Operating Manual.