Dmiclassic C - LOGICDATA DMIclassic Series Operating Manual

DMICLASSIC FAMILY - OPERATING MANUAL // PAGE 20

7.2 DMICLASSIC C

When a DMIclassic C Handset is installed alongside the DYNAMIC MOTION system, error messages are
displayed on the digital display panel. These are as follows:
SIGNAL MESSAGE
Hot
Overheating protection has been
activated.
The display shows
"Hot".
The system has recognized a collision.
ISP
The display shows
"ISP".
Con
The system has recognized a connection
error.
The display shows
"Con".
C17
An internal error has occurred.
Handset displays error
code "CXX" (e.g. C17).
REQUIRED ACTIONS
Wait for the overheated components to
cool.
Release all Keys and wait for the Drive
Back function to be completed.
Release all Keys and wait for 5 seconds.
Then, try again.
Disconnect the Power Unit from the
Mains. Then, disconnect System from the
Power Unit. Reconnect the system again,
then operate the DM System as normal.
Read the table below to find the correct
response to the error code shown.