Marine Lights And Convenience Outlets - Carrier Aero 39MN MW03-110 Series Installation, Start-Up And Service Instructions Manual

Marine Lights and Convenience Outlets

Marine lights can be factory-installed with or without a GFCI
(ground fault circuit interrupter) convenience outlet. See Fig. 170
and 171 for a typical marine light with a convenience outlet and
Fig. 172 and 173 for a typical marine light without a convenience
outlet. To connect power to the light, route the supply voltage to
BLACK WIRE
WHITE WIRE
Fig. 170 — Marine Light with Convenience Outlet and Switch, Indoor Installation
OUTDOOR SWITCH
ASSEMBLY WITH OUTLET
BLACK WIRE
SWITCH COVER
Fig. 171 — Marine Light with Convenience Outlet and Switch, Outdoor Installation
INDOOR SWITCH
ASSEMBLY WITH OUTLET
BLACK WIRE
GREEN WIRE
either the base of the light (interior) or to the switch/convenience
outlet assembly (exterior).
The factory installs a low-wattage LED bulb. However, if an in-
candescent bulb is installed the existing wiring can handle the in-
creased amp draw.
SEAL
PERMAGUM BEAD
UNIT EXTERIOR
SEAL
PERMAGUM
BEAD
UNIT
EXTERIOR
WHITE WIRE
BLACK WIRE
203
UNIT SIDE PANEL
(TYPICAL)
LIGHT ASSEMBLY
UNIT
INTERIOR
UNIT SIDE PANEL
(TYPICAL)
LIGHT
UNIT
ASSEMBLY
INTERIOR
A39-4482