Pre-Installation And Application Warnings - Directed DIRECTECHS DB3 Installation Manual

Pre-installation and application warnings

Firmware notes: This section highlights important information for this specific firmware and will assist in pricing
accordingly, as well as bringing awareness to any operational or vehicle limitations.
T-Harness
compatible
Š All connectors are displayed from the wire side (unless specified otherwise).
Š Refer to the "Vehicle connections" following the installation diagram.
General notes: This section highlights important information for this specific firmware.
Tach wire is an optional connection required on some remote starters, which do not support a tach signal in D2D.
[1]
The installation of an aftermarket hood pin is ONLY required on vehicles that are NOT equipped with a factory hood pin or if
[2]
NOT supported in data.
The vehicle MUST be disarmed for the power tailgate to operate.
[3]
Only required to turn off autolights during idle mode shutdown.
[4]
4
403.NISS06 3.27 2016 Nissan Rogue (Smart Key)
©2023 Directed. All rights reserved.
Keys required for 1 Keys required
programming for operation
0