Pre-Installation And Application Warnings - Directed DIRECTECHS DB3 Installation Manual

Pre-installation and application warnings

This section highlights important information for this specific firmware and will assist in pricing accordingly, as
START HERE
well as bringing awareness to any operational or vehicle limitations.
Compatibilities and Requirements
T-Harness
compatible
Vehicle Takeover
Firmware notes
The optional Plug & Play THNISS3D T-Harness is sold separately.
Š
Š The OBDII Diagnostic Connector features will remain the same even when the T-Harness is installed.
Š Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic connector.
Š Refer to the "Vehicle connections" following the installation diagram.
Footnotes
[1] Hood pin: The installation of an aftermarket hood pin is only required on vehicles that are not equipped with a factory
hood pin, or if not supported in data.
[2] Tach:
The tach wire is an optional connection required on some remote starters, which do not support a tach signal in D2D.
4
403.NISS3HT 3.17 2010 Nissan Altima (Smart Key)
©2023 Directed. All rights reserved.
THNISS3D
Refer to the Quick Reference Guide section for more details.
Keys required for 1 Keys required
programming for operation
0