Pre-Installation And Application Warnings - Directed DIRECTECHS DB3 Installation Manual

Pre-installation and application warnings

Firmware notes: This section highlights important information for this specific firmware and will assist in
pricing accordingly, as well as bringing awareness to any operational or vehicle limitations.
T-Harness
compatible
Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic
Š
connector.
Refer to the "Vehicle connections" following the installation diagram.
Š
General notes: This section highlights important information for this specific firmware.
Tach wire is an optional connection required on some remote starters, which do not support a tach signal in D2D.
[1]
Vehicles with an OEM alarm: When flashing the interface, enable 'With OEM Alarm', under 'Data Configuration'.
[2]
A resistor is required for parking lights. Refer to the Vehicle connections section for more details.
[3]
4
403.CHRYSLER2 3.13 2003 Jeep Liberty
©2023 Directed. All rights reserved.
Keys required for 1 Keys required for
programming operation
0