Directed DB3 Installation Manual
Hide thumbs
Also See for DB3:
- Installation manual (25 pages) ,
- Manual (6 pages) ,
- Installation manual (21 pages)
Advertisement
Quick Links
INSTALLATION GUIDE
DB3
2014 Chevrolet Captiva Sport - 403.GM11 1.08
Designed by Installers for Installers
© 2017 Directed, Vista CA
This product is intended for installation by a professional installer only! Attempts to install this
product by a person other than a trained professional may result in severe damage to a vehicle's
electrical system and components.
Advertisement
Related Manuals for Directed DB3
Summary of Contents for Directed DB3
- Page 1 2014 Chevrolet Captiva Sport - 403.GM11 1.08 Designed by Installers for Installers © 2017 Directed, Vista CA This product is intended for installation by a professional installer only! Attempts to install this product by a person other than a trained professional may result in severe damage to a vehicle’s...
-
Page 2: Table Of Contents
Contents Introduction Pre-installation and application warnings Wiring diagram Vehicle connections Connecting the module Module programming LED diagnostics and troubleshooting Soft reset Hard reset Feature programming Feature and option list Limited one year consumer warranty Quick reference guide... - Page 3 The following safety warnings must be observed at all times: • Due to the complexity of this system, installation of this product must only be performed by an authorized Directed dealer. • When properly installed, this system can start the vehicle via a command signal from the remote control. Therefore, never operate the system in an area that does not have adequate ventilation.
-
Page 4: Introduction
Introduction DB3 is an all-in-one door lock and override module. Warning! This module can only be flashed and configured using DirectLink at www.directechs.com or using the Directechs Mobile application for smartphones. Refer to “Connecting the module” for more information. This solution is compatible with the 2014 Chevrolet Captiva Sport and offers the following features: •... -
Page 5: Pre-Installation And Application Warnings
For vehicle specific accessory and ignition connections, refer to "Vehicle connections". Additional parts required (maximum required): Resistor 100Ω Fuse 7.5A Diode 6A 1 x 1A Diodes 0 x Resistor 0 x Fuse 0 x Relay 403.GM11 1.08 2014 Chevrolet Captiva Sport © 2017-01-27 Directed. All rights reserved. -
Page 6: Wiring Diagram
X2 connector X6 connector (-) Driver (-) Driver (-) Parking Lights: Door Trigger: Door Trigger: Pin 8 Gray/Black, Gray/Black, pin 13 pin 10 Drivers Window Switch (in drivers door) 403.GM11 1.08 2014 Chevrolet Captiva Sport © 2017-01-27 Directed. All rights reserved. -
Page 7: Vehicle Connections
No Connection H2/9 Violet/Brown No Connection No Connection H2/10 Yellow/Black No Connection No Connection H2/11 Orange/Black No Connection No Connection H2/12 Blue/Red W2W Only – (-) Hood Status Output 403.GM11 1.08 2014 Chevrolet Captiva Sport © 2017-01-27 Directed. All rights reserved. - Page 8 (Data) TX H4/2 Black (-) Ground H4/3 Blue (Data) RX H4/4 (+) 12 Volt RF 2-pin white connector (H5) Module Conn./Pin Color Description H5/1 RF Loop H5/2 RF Loop 403.GM11 1.08 2014 Chevrolet Captiva Sport © 2017-01-27 Directed. All rights reserved.
-
Page 9: Connecting The Module
(12-pin) (D2D) (10-pin) (14-pin) W2W installation If required: Connect the 10-pin and 12-pin harnesses to the module, then connect the 14-pin harness to the module. (12-pin) (10-pin) (14-pin) 403.GM11 1.08 2014 Chevrolet Captiva Sport © 2017-01-27 Directed. All rights reserved. -
Page 10: Module Programming
Note: This may take up to 1 minute. Turn the vehicle ignition OFF and remove the key once the module is successfully programmed. You have successfully completed the module programming sequence. 403.GM11 1.08 2014 Chevrolet Captiva Sport © 2017-01-27 Directed. All rights reserved.