Pre-installation and application warnings
Firmware notes: This section highlights important information for this specific firmware and will assist in pricing
accordingly, as well as bringing awareness to any operational or vehicle limitations.
T-Harness
compatible
Important:
This firmware has negative outputs for the door locks function. Vehicles with positive and/or 5-wire/ reverse circuit
requires an optional relay. Refer to Tech Tip 1041 - Door lock wiring guide for relay assistance.
Important!
A DS4+ module is required for this installation, as the Relay harness (H2), 10-pin white connector is used.
Key2GO is required if only one master key is available. You can program the interface without the need for Key2GO if two master
keys are present.
Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic connector.
It is important to check that the fuses are positioned correctly in the module. Proper fuse positioning is displayed on each wiring
diagram.
Refer to the "Vehicle connections" following the installation diagram.
General notes: This section highlights important information for this specific firmware.
The installation of an aftermarket hood pin is ONLY required on vehicles that are NOT equipped with a factory hood pin.
[1]
The siren is ONLY required when enabling the security features during module flashing.
[2]
The Green wire is ONLY required for starter disable and antigrind applications.
[3]
If present, CAN connections are ONLY required if using in conjunction with SmartStart.
[4]
Required ONLY when enabling the security features during module flashing or Remote Start Only installs in vehicles with manual
[5]
transmission.
Connections ONLY required on vehicles with (+) Accessory 3.
[6]
5
933.FORD1 4.22.198.12 2005 Ford Taurus
©2023 Directed. All rights
Keys
1 or 2
required for
programming
Keys required
0
for operation