Input Of Formatted Commands - Landis+Gyr E650 Series User Manual

74/93
5.8

Input of Formatted Commands

© Landis+Gyr AG
The following operating data or meter characteristics can be modified by
the input of formatted commands. The user of formatted commands, how-
ever, must have the necessary access authorisation according to the secu-
rity system.
The following commands can be used both according to IEC 62056-21 and
also with dlms:

Set time/date

Set identification numbers for the energy supply company and for the
manufacturer (by line).

Initiation of reset via interface

Neutralise reset inputs KA/KB

Set/reset reset counter

Control tariff rates via interface

Set/reset energy registers

Set/reset total energy registers

Set/reset demand maximum registers

Set/reset power factor registers

Reset stored values

Reset battery hours counter

Reset voltage failures registers

Switch on/off increased resolution (test mode)

Define by additional parameters whether the optical test output for
active energy in test mode supplies active or reactive energy pulses

Delete error messages

Change passwords P1,P2 and W5

Reset load profile 1 / load profile 2

Reset event log

Reset dedicated event log groups
The following commands can only be executed with dlms:

Reset event register
– Under- and overvoltages
– Demand messages
– Current messages
– Power factor messages

Set thresholds for messages
Formatted commands are transferred to the meter with a suitable aid (hand
held terminal or laptop) via the optical interface or via an interface circuit of
the communication unit.
D000030110 d – E650 Series 3 (ZMD400AT/CT, ZFD400AT/CT) – User Manual
Operation