Table of Contents
Advertisement
68/93
Value display
Set mode
5.5
Alert LED
© Landis+Gyr AG
The first value of the list associated with the present menu is displayed by
pressing the display key "down" or "up" for longer (at least 2 seconds) (as
for the display list).
The next list value appears for every further brief operation of the "down"
display key. Brief operation of the "up" key again displays the preceding
value. The sequence of values in the list is determined by the parameter-
isation.
A rapid run is started by holding down the display key "down" or "up" (at
least 2 seconds). The main values of the list are then displayed while the
key remains pressed, but no stored values.
To return to the menu level from the list at the end of the display list press
the display key "down" or "up" for longer (at least 2 seconds).
Both display keys ("down" and "up") must be pressed simultaneously to
return to the operating display from the list.
Values can be changed in the value display of the set mode with the aid of
the reset key and display keys (for setting time and date, identification
numbers, battery hours counter, etc.). The procedure is described in
section 5.9 "Changing Values in Set Mode".
The red alert LED on the main face plate indicates that certain event(s)
have occurred. What event(s) trigger the alert LED can be set by
parameterisation.
Alert LED
Three-phase four-wire meter
ZMD410CT44.4207 S3
3 x 230/400 V
T1 T2 T3
Fig. 5.9
Alert LED
D000030110 d – E650 Series 3 (ZMD400AT/CT, ZFD400AT/CT) – User Manual
Landis+Gyr Dialog
imp
imp
Cl. 1
10000
kvarh
kWh
Nr. XX XXX XXX
5(10) A
50 Hz
20XX
Readout
Cl. 1
SET Test
Operation
Advertisement
Table of Contents
