Scope Of Supply; Returns; Transport And Storage; Transport And Storage Conditions - Hettich UNIVERSAL 320 Operating Instructions Manual

Transport and storage

3.7

Scope of supply

3.8

Returns

4 Transport and storage
4.1

Transport and storage conditions

Transport conditions
16 / 44
The following accessories are supplied with the centrifuge:
■
1 hex key (SW5 x 100)
■
1 grease for the trunnions
■
1 power cable
■
1 user manual
■
1 instruction sheet, transport lock
Rotors and the corresponding accessories are supplied depending on the
order.
An original Return Material Authorisation (RMA) form from the manufacturer
must always be requested for a return. Secure and reliable acceptance and
booking in of the goods with the manufacturer is not possible without an
original RMA form from the manufacturer. The Return Material Authorisation
(RMA) form contains a Declaration of No Objection (UBE), which must be
completed in full and enclosed with the return.
If the device and/or accessories are returned to the manufacturer, the
complete return shipment must be cleaned and decontaminated by the
sender. If returns are not cleaned and/or decontaminated or are insuffi-
ciently cleaned and/or decontaminated, this will be performed by the manu-
facturer and charged to the sender.
The original transport locks must be attached for return shipment, see
Chapter 4 'Transport and storage' on page 16 . The device must be
⮫
shipped in its original packaging.
NOTICE
Damage to the device due to failure to use the transport
locks.
−
Secure the transport locks before transporting the
device.
NOTICE
Damage to the device due to condensation.
There is a risk of condensation forming on electrical com-
ponents when component surfaces are cold and the sur-
rounding air is warmer. The condensation that forms may
cause a short circuit and/or destroy electronics.
−
Warm the device up for at least 3 hours in a warm room
before connecting it to the mains.
or
−
Warm up for 30 minutes in a cold room.
Rev.: 04 / 11.2023 AB1401en_SA