Advertisement
4 flashes
= flat battery.
5 flashes
= serious error - 3.
6 flashes
= serious error - 4 (control circuit temperature too high).
7 flashes
= serious error - 5 (brake malfunction).
8 flashes
= serious error - 6 (brake malfunction).
9 flashes
= serious error - 7.
10 flashes
= serious error - 8.
11 flashes
= serious error - 9.
The motor repeats the report message on the status of the installation by performing
some brief movements when a movement is commanded. To understand the signifi-
cance of these movements read Table D.
TABLE D – Movement signals
No. of MOVEMENTS
Meaning
= at least 1 transmitter memorised and 2 limit positions
0 movements
programmed.
= no transmitter memorised (the limit switch status is
1 movement
not shown by the movements).
= at least 1 transmitter memorised and at least 1 limit
2 movements
position still to be programmed.
5 movements
= serious motor memory error.
What to do if...
(troubleshooting guide)
In general, to better identify the problem, refer to Table C (and D), section 5.8.
q When an Up command is sent, the motor does not start:
This can happen if the awning is near the Upper limit switch ("0"). In this case you
must lower the awning a little bit and give the Raise command again.
q The system operates in the emergency condition with an operator pre-
sent (hold-to-run):
– Check to see if the motor has undergone a significant electrical or mechanical
shock.
– Make sure each part of the motor is still in good condition.
– Delete the UP ("0") and DOWN ("1") limit position and reprogram them.
17 – English
Disposal of the product
As in installation, also at the end of product lifetime, the disassembly and scrapping
operations must be performed by qualified personnel.
This product comprises various types of materials: some may be recycled others
must be disposed of. Seek information on the recycling and disposal systems envis-
aged by the local regulations in your area for this product category. Caution! – some
parts of the product may contain pollutant or hazardous substances which, if dis-
posed of into the environment, may cause serious damage to the environment or
physical health.
As indicated by the symbol on the left, disposal of this product in domes-
tic waste is strictly prohibited. Separate the waste into categories for dis-
posal, according to the methods envisaged by current legislation in your
area, or return the product to the retailer when purchasing a new version.
Caution! – Local legislation may envisage serious fines in the event of abusive dis-
posal of this product.
The packing materials of the product must be disposed of in compliance with local
regulations.
Technical Characteristics
Refer to the technical characteristics stated on the motor's nameplate.
Note: • All technical specifications stated herein refer to an ambient temperature of
20° C (± 5° C). • Nice S.p.A. reserves the right to apply modifications to products
at any time when deemed necessary, maintaining the same intended use and func-
tionality.
Simplified EU declaration of conformity
Hereby, NICE S.p.A., declares that the radio equipment type E EDGE SI 228 LI ION
is in compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet
address:
https://www.niceforyou.com/en/support.
COMPLIANCE WITH THE FCC RULES (PART 15) AND RSS-210 RULES
This device complies with Industry Canada's licence-exempt RSS-210s, and with
Part 15 of the FCC rules of the United States of America. Operation is subject to
the following two conditions: (1) this device may not cause interference; (2) this de-
vice must accept any interference, including interference that may cause undesired
operation of the device. Any changes or modifications made to this device, without
the express permission of the manufacturer, may void the user's authority to operate
this device.
Advertisement
