Advertisement
A.6 - Memorisation of a climate sensor connected via radio
A
NOTES AND WARNINGS
• To run this procedure you need the climate sensor you want to memorise, chosen from the "Nice Screen" catalogue, and an old transmitter memorised in Mode I
(see par. 3.4.1-A).
• When performing the procedure, you can cancel the programming at any time by holding down n and t together for 4 seconds. Alternatively, do not press any keys
and wait 60 seconds for the motor to perform 6 movements.
1
= 10 sec
P1
sensor
On the climate SENSOR: hold down
the yellow button "P1";
A.7 - TOTAL or PARTIAL deletion of memory
A
NOTES AND WARNINGS
• In order to carry out the following deletion procedures, the transmitter must be memorised in mode I.
A.7.1 - Procedure run with a memorised transmitter
1
(x 1)
PRG
Press and release
count 2 movements.
the button (1 time);
4
(x 1)
PRG
Press and release
count 4 movements.
the button (1 time);
5
(x 1)
PRG
Press and release the
count 5 movements.
button (1 time);
5
= 5 sec
release it after 5
Hold down the but-
ton;
seconds;
11 – English
2
P1
OLD
release it after 10
On the OLD transmitter: press
seconds;
and release (3 times) any button.
2
(x 1)
2
PRG
Press and release
count 2 movements.
the button (1 time);
...
5
Select one of the following potions and execute it:
• option A – delete the motor's ENTIRE memory
• option B – delete ALL memorised transmitters
4
• option C – delete ONE memorised transmitter
• option D – delete ALL positions ("0", "1", "H", etc.). Caution! – This deletion should only be performed if you wish repro-
gram the distances.
end
5
3
count 3 movements.
3
(x 3)
...
sensor
On the climate sensor: press and
release (1 time) the yellow button
"P1";
3
(x 1)
2
PRG
Press and release
the button (1 time);
5
= 5 sec
Hold down the button;
release it after 5 seconds;
6
= 5 sec
On the transmitter to be deleted: press and hold
any button or the button memorised in mode 2 or
the button corresponding to position H or the climate
sensor button;
(x 1)
P1
count 3 movements (= sen-
sor memorised). If the sys-
tem makes 6 movements (=
memory locked or full, sensor
not memorised).
4
3
count 3 movements.
end
5
count 5 movements.
end
5
count 5 movements.
end
3
Advertisement
